Trapdest Object States - HP T9576G06 Management Manual

Introduction to SCF for the SNMP Agent
A pound sign (#)
A logical identifier representing the TRAPDEST object definition
The logical identifier consists of an alphabetic character followed by up to six additional
alphanumeric characters. For example:
$ZSNMP.#TRAP1
In the SCF command syntax descriptions, the logical identifier associated with a trap
destination configuration is referred to as its trapdest-name. The syntax for
specifying a TRAPDEST object type:
command TRAPDEST $agent-process.#trapdest-name
Note. If you set a default PROCESS with the ASSUME PROCESS command, you can omit
the NonStop agent process name and period and just specify #trapdest-name. For
example:
-> ASSUME PROCESS $ZSNMP
-> INFO TRAPDEST #TRAP1
-> STATUS TRAPDEST #TRAP1
Wildcard Support: TRAPDEST Object
The use of the asterisk (*) as a wildcard is supported in TRAPDEST object name
specifications for the following commands:
ABORT INFO
ALTER START
DELETE STATUS
The following example returns information about all TRAPDEST objects whose object
name began with #TRAP:
-> INFO TRAPDEST $ZSNMP.#TRAP*
The following example returns information about all TRAPDEST objects defined for
NonStop agent process $ZSNMP:
-> ASSUME PROCESS $ZSNMP
-> INFO TRAPDEST *

TRAPDEST Object States

The TRAPDEST object is always in one of the DEFINED, STARTING, STARTED, or
STOPPED states.
Table 4-4 describes the states supported for the TRAPDEST object.
STOP
SNMP Configuration and Management Manual—424777-006
4- 17
TRAPDEST Object States