Scsi Test; Trace Route - Dell Brocade Adapters Troubleshooting Manual

4. Select Queue Test.
5. Click Start.

SCSI test

Use the fcdiag --scsitest command to test SCSI components and display discovered LUN
information, such as LUN number, device type and qualifier, vendor ID, product ID, revision number,
size of LUN, and LUN status.
fcdiag -–scsitest <port_id> <rpwwn> [-l <lpwwn>]
where:
port_id
rpwwn
lpwwn

Trace route

Use the BCU and HCM to trace the SAN path between the adapter and remote end point.
Tracing the route through BCU
Use the fcdiag --traceroute BCU command to trace the route between end points.
fcdiag -–fctraceroute <port_id> <rpwwn> [-l <lpwwn>]
where:
port_id
rpwwn
lpwwn
Tracing the route through HCM
Use the FC Trace Route test to trace the route between the adapter port and a Fibre Channel target
port. To run this test, use the following steps:
1. Launch the HCM.
2. Select Configure > Diagnostics to display the Diagnostics dialog box.
3. Click the FC Protocol Tests tab.
4. Select FC Trace Route.
5. Select the adapter port and target for which you wish to trace the route.
Brocade Adapters Troubleshooting Guide
53-1002145-01
ID of the port from that you want to test. This could be the PWWN, port
hardware path, or user-specified port name. This could also be the
adapter-index/port-index. For example, to specify adapter 1, port 1 use 1/1
as the port identification.
Remote PWWN to which you want to trace the route.
Logical PWWN. 0 indicates the base port or else the virtual port.
ID of the port from which you want to trace the route. This could be the
PWWN, port hardware path, or user-specified port name. This could also be
the adapter-index/port-index. For example, to specify adapter 1, port 1 use
1/1 as the port identification.
Remote PWWN to which you want to trace the route.
Logical PWWN. 0 indicates the base port.
3
Diagnostics
95