Adapter Driver Event Messages - Dell Brocade Adapters Troubleshooting Manual

A

Adapter driver event messages

TABLE 12
Adapter BIOS messages (continued)
Message
Failed:<Disk: PWWN<Target's PWWN>
LUN<LUN Id>. Adapter<no>
Adapter<no> : BIOS is disabled
Adapter<no> : Link initialization
failed. Disabling BIOS
Boot device discovery failed. Disabling
BIOS.
Brocade BIOS installed successfully
Adapter driver event messages
Table 13
host system logs and the HCM master log. Events are organized as originating from the network
driver only, storage driver only, or network and storage driver.
TABLE 13
Driver event messages
Message
Network Driver Events (CNAS only)
Base port link up: Hardware Address
= [Base port MAC].
Base port link down: Hardware
Address = [Base port MAC].
Base port Ethernet Link is enabled:
Hardware Address = [Base port
MAC].
122
Cause
This adapter is unable to connect to the
configured boot device. This error message is
displayed only when boot option is set to Flash
Values through the Brocade BIOS
Configuration Utility.
BIOS is disabled for this adapter.
Unable to bring up the link for this adapter.
The boot option is set to Fabric Discovered or
First LUN through the Brocade BIOS
Configuration Utility, and the adapter is unable
to discover any boot device.
This message displays if any adapters in the
system are able to connect to a boot device.
provides details on event messages generated by adapter drivers. These events display in
Severity Event Type
Information Network driver
Warning Network driver
Information Network driver
Recommended Action
1 Check the zoning information on the switch
and verify if the target's WWN is in the
same zone as the initiator's WWN.
2 Check that there is path configured
between the initiator and the target boot
device.
If booting through this adapter is desired, then
launch the Brocade BIOS Configuration Utility by
pressing Ctrl-B or Alt-B, then enable BIOS on the
adapter port where connection is required.
Check connectivity between the adapter port
and the switch.
If booting through this adapter is not desired,
then ignore this message.
If booting through this adapter is desired:
1 Launch the Brocade BIOS Configuration
Utility by pressing Ctrl-B or Alt-B.
2 For the desired port, select Auto Discover
for the Boot LUN field in the Adapter
Settings menu.
3 Check if any boot devices are visible. If
none are visible, then connect a boot
device and repeat step 2. You should see
the target and LUN information displayed
during the discovery process.
None.
Category Sub Cause
Category
10 Up Base port Ethernet
(EthPort) link is up.
10 Down Base port Ethernet
(EthPort) link is down.
10 Enabled Ethernet port
(EthPort) enabled by user.
Brocade Adapters Troubleshooting Guide
Action
No action
required.
No action
required.
No action
required.
53-1002145-01