Dell Brocade Adapters Troubleshooting Manual page 154

B
HCM and Installer Message Reference
TABLE 14
Message
Enter a valid host name
or IP address
Enter a valid number for
the test cycle.
Event Filter cannot be
launched while the Event
Properties dialog is
open.
Failed to connect to the
Agent
Failed to create virtual
port:
Failed to refresh the
team data due to an
unexpected error.
<Runtime Reason>
Failed to restore the
VLAN and Team
configurations. Reason:
Caused by no saved
configurations.
Failed to restore the
VLAN and Team
configurations.
<Runtime Reason>
Fibre Channel Trunking
cannot be enabled on
the adapter {0} while
QoS or TRL is enabled on
the port {1}.
Found duplicate
name(s). Please resolve.
Frame Count for PCI
Loopback Test cannot be
empty. Enter valid data.
130
Host Connectivity Manager messages (continued)
Cause
Occurs when the user clicks Add button in the
Syslog Server Configuration dialog box without
providing any host name or IP address or by
providing an invalid host name or IP address.
Occurs when invalid number is provided in Test
Cycle field.
Occurs when the user tries to launch the
Master Log Filter dialog box while the Event
Properties dialog box is open.
Occurs when the agent connection is lost.
Occurs when there is a error while creating
virtual ports.
Occurs when an error occurs while refreshing
the team data.
Occurs when there is VLAN/Teaming
configuration file is not present to restore when
user clicks Tool > Restore Data > VLAN and
Team.
Occurs when the restore of VLAN and Team
configuration fails in HCM.
Quality of Service (QoS) or Target Rate Limiting
(TRL) is enabled on an associated port.
Occurs when the user selects
User/Administrator will manually fix option in
the Duplicated Names dialog box and does not
provide a unique name.
Occurs when the Frame Count field is left
empty while executing a PCI loopback test.
Corrective Action or Notes
Enter a valid host name and IP
address in the host name field of
the Setup for Discovery dialog box.
Enter a valid host name/IP address
in the Host name/IP address field of
Syslog Server Configuration dialog
box.
Enter a valid number within the limit
for the test cycle.
Close the Event Properties dialog
box, and then launch the Master Log
Filter dialog box.
Start the HCM agent service, and
then proceed.
Determine why the error happens
when creating a virtual port.
Determine why the error happens,
and then proceed.
The VLAN and Teaming
configuration save will only occur
during installation or upgrade of
network or intermediate drivers
through the Brocade Adapters
Software Installer (BASI). There
must be a saved configuration for a
successful restore.
Retry the operation.
Make sure QoS or TRL is disabled in
any of the associated ports.
Provide a unique name in the
Duplicated Names dialog box.
Error message.
Brocade Adapters Troubleshooting Guide
53-1002145-01