Dell Brocade Adapters Troubleshooting Manual page 162

B
HCM and Installer Message Reference
TABLE 15
Message
Disk space calculation
Available space is <Available space>. Please free up at
least 50 MB in /opt and re-attempt the installation.
Do you want to back up the HCM configurations?
Configurations are stored in data directory.
<Three buttons displays like Don't Backup, Backup and
Cancel>
File backup
Successfully backed up
<brcd_initrd_backup_filename> in /boot.
File backup
There is a back up file <brcd_initrd_backup_filename>
already available in /boot. Do you want to overwrite?
Found Backed up data.
Backed up configuration directory of HCM
<backedup_gui_version> dated <Backup_Date> is
found at <Backup_Directory>.
Do you want to restore old configurations?
No matching binary rpm found
Do you want to install noarch rpm?
Note:
- noarch rpm is not recommended for RHEL/SLES.
- noarch rpm requires kernel devel/source rpm and
GCC.
Path is not Valid.
You have entered an invalid backup output directory.
Please make sure the directory path is correct.
Pre-Installation Message
It is strongly recommended that you quit all HCM
application running on this machine before continuing
with the Upgrade/Reinstall.
Pre-requisite check is done...
Pre-Uninstallation Message
It is strongly recommended that you quit all HCM
application running on this machine before continuing
with the Upgrade/Reinstall.
138
Brocade Adapter Software Installer messages (continued)
Cause Corrective Action or Notes
Occurs when the available Free at least 50MB in
space in /opt is less than /opt, and then try
50MB. installation.
Occurs when you remove If you want to back up the
the application. data, click on "Backup" or
else click "Don't backup."
Occurs when Initrd file is No action required.
backedup successfully in
/boot.
Occurs when a backup file When user wish to
named overwrite the existing
<brcd_initrd_backup_file backup file press "Yes"
name> is already else "No"
available in /boot
Occurs during the course If the user wishes to
of installation when a restore the backed-up
backup data is already data, the user can give
present in the system. "Yes" else "No"
Occurs when a matching Click Yes to proceed with
binary rpm is not found. the installation using the
noarch rpm or click No to
stop installation.
Occurs if provide an Enter a valid path to
invalid path name or backup the files.
leave the path field blank.
Occurs after the Stop HCM from running
upgrade/reinstall before upgrading or
message. reinstalling the software.
Occurs when driver's Information message.
pre-requisite check is
completed.
Occurs during removing Close HCM or the installer
the HCM application. will close it before
proceeding with software
removal.
Brocade Adapters Troubleshooting Guide
53-1002145-01