Performance Optimization; In This Chapter; Tuning Storage Drivers; Linux Tuning - Dell Brocade Adapters Troubleshooting Manual

Performance Optimization

In this chapter

Tuning storage drivers

This section provides resources for optimizing performance in adapters by tuning the unified
storage drivers on Linux, Windows, Solaris, and VMware systems. To optimize performance for
CNAs and Fabric Adapter ports configured in CNA or NIC mode, also use resources under
network drivers (CNA or NIC)"

Linux tuning

Linux disk I/O scheduling reorders, delays, and merges requests to achieve better throughput and
lower latency than would happen if all the requests were sent straight to the disk. Linux 2.6 has
four different disk I/O schedulers: noop, deadline, anticipatory and completely fair queuing.
Enabling the "noop" scheduler avoids any delays in queuing of I/O commands. This helps in
achieving higher I/O rates by queuing multiple outstanding I/O requests to each disk.
To enable the noop scheduler, run the following commands on your system.
for i in /sys/block/sd[b-z]/queue/scheduler
do
echo noop > $i
done
NOTE
You must disable the default scheduler because it is not tuned for achieving the maximum I/O
performance.
For performance tuning on Linux, refer to the following publications:
•
•
•
•
Brocade Adapters Troubleshooting Guide
53-1002145-01
•
Tuning storage drivers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 113
•
Tuning network drivers (CNA or NIC) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 116
Workload Dependent Performance Evaluation of the Linux 2.6 IO Schedulers
Heger, D., Pratt, S., Linux Symposium, Ottawa, Canada, July 2004
Optimizing Linux Performance
HP Professional Books, ISBN: 0-13-148682-9
Performance Tuning for Linux Servers
Sandra K. Johnson, Gerrit Huizenga, Badari Pulavarty, IBM Press, ISBN: 013144753X
Linux Kernel Development
on page 116.
Chapter
4
"Tuning
113