Dell Brocade Adapters Troubleshooting Manual page 149

TABLE 13
Driver event messages (continued)
Message
Authentication unsuccessful for base
port: WWN = [base port WWN or
MAC].
Base port enabled: Hardware
Address = [base port WWN or MAC].
Base port disabled: Hardware
Address = [base port WWN or MAC].
Base port online: WWN = [Base Port
WWN].
Base port offline: WWN = [Base Port
WWN].
Base port (WWN = [base port WWN
or MAC]) lost fabric connectivity.
Heart Beat of IOC [IOC instance
number] is good.
Heart Beat of IOC [IOC instance
number] has failed.
IOC [IOC instance number] is
enabled.
IOC [IOC instance number] is
disabled.
New adapter found: SN = [adapter
serial number] base port WWN =
[Base port WWN].
New SFP found: port [base port
number], Hardware Address = [Base
port WWN or MAC]..
QOS negotiation failed for base port:
WWN = base port WWN or MAC].
Brocade Adapters Troubleshooting Guide
53-1002145-01
Severity Event Type
Error Network and
storage driver
Information Network and
storage driver
Warning Network and
storage driver
Information Network and
storage driver
Warning Network and
storage driver
Error Network and
storage driver
Information Network and
storage driver
Critical Network and
storage driver
Information Network and
storage driver
Warning Network and
storage driver
Information Network and
storage driver
Information Network and
storage driver
(stand-up
adapters only)
Warning Network and
storage driver
Adapter driver event messages
Category Sub Cause
Category
2 (Port) Failure Authentication
failure.
2 (Port) Enabled Base port enabled
by user command.
2 (Port) Disabled Base port disabled
by user command.
2 (Port) Online Base port logged
into fabric.
2 (Port) Offline Base port logged
out of fabric.
2 (Port) Logout Base port lost
connection with
fabric.
9 (TOC) Restart Successful restart
of firmware after a
failure.
9 (TOC) Crash Firmware not
responding.
9 (TOC) Enabled Adapter firmware
started by user
command.
9 (TOC) Disabled Adapter firmware
stopped by user
command.
1 Added Adapter added to
(Adapter) host.
2 (Port) Found User plugged in an
SFP.
2 (Port) Failure QoS negotiation
failed.
A
Action
Mismatch of
FC-SP
configuration
between switch
and HBA. Also,
check the
authentication
secret setting.
No action
required.
No action
required.
No action
required.
No action
required.
Check switch and
HBA
configuration.
Also, check SFP
and cable
connection
stand-up
adapters.
No action
required.
Collect all error
information and
restart the
firmware. Invoke
bfa_supportsave.
No action
required.
No action
required.
No action
required.
No action
required.
Check switch and
HBA
configuration.
125