Dell Brocade Adapters Troubleshooting Manual page 164

B
HCM and Installer Message Reference
TABLE 15
Message
System dependencies not available.
GCC and Kernel rpms are required for installing Storage
and Network Driver and HCM and Storage and Network
Driver.
Variable "allow_unsupported_modules" in
/etc/modprobe.d/unsupported-modules file is set to
"0", please change it to "1" before continuing
installation otherwise the driver module will not be
loaded.
System dependencies not available.
GCC and Kernel rpms are required for installing Storage
and Network Driver and HCM and Storage and Network
Driver.
The following component(s) exist in your system.
Product : <Already installed version>
<Components list displays with tabular format>
HCM/ configuration preference
- option 1 -> Install with existing configuration
- option 2 -> Install with default configuration
<Two buttons displays like Continue, Exit>
The following component(s) exist in your system.
Product : <Installer Driver Name>
<Components list displays with tabular format>
<Two buttons displays like Continue and Exit >
Unable to start the driver update.
VLAN ID cannot be empty. Enter a valid VLAN ID.
Warning message
If booting over Brocade HBA, you must have a version of
driver installed before you restart the system.
Would you like to overwrite the existing driver?
The adapters on the system have a better driver version
than the one you are trying to install.
Click OK to continue.
140
Brocade Adapter Software Installer messages (continued)
Cause Corrective Action or Notes
Occurs when you install Change the "0" in variable
drivers on a Linux system "allow_unsupported_mod
ules" present in
that does not contain the
GCC and kernel rpm and /etc/modprobe.d/unsupp
when the variable orted-modules file to "1."
"allow_unsupported_mod
ules" in
Load the GCC and Kernel
/etc/modprobe.d/unsupp
rpms on the system, and
orted-modules file is set
install the drivers.
to "0"
Occurs when you install Load the GCC and kernel
drivers on Linux systems rpms on the system and
that do not contain the then install the drivers.
GCC and Kernel rpm.
Occurs when you try to Select whether you want
overwrite currently to install software using
installed software with a the default configuration
newer version. or the configuration that
exists for the currently
installed software.
Occurs when a driver was Continue installing new
installed using native components or exit the
installer scripts or system installation.
commands and you are
trying to overwrite with a
newer driver.
Occurs when driver Information message.
update not able to start.
Occurs when the user add Provide a valid VLAN ID
a new VLAN without while creating VLAN.
providing a VLAN ID in the
VLAN Configuration dialog
box.
Occurs on Linux systems If booting a Brocade HBA,
during removal of driver make sure driver is
or HCM and driver. installed in the system
before rebooting.
Occurs when the system If you want to overwrite
has a better driver version the existing driver, click
than the one you are OK to continue.
installing.
Brocade Adapters Troubleshooting Guide
53-1002145-01