Creating Secure Fabric Os Policies Other Than The Fcs Policy - HP StorageWorks MSA 2/8 - SAN Switch User Manual

Creating Secure Fabric OS Policies

Creating Secure Fabric OS Policies Other Than the FCS Policy

The FCS policy is automatically created when Secure Mode is enabled. You can
create the other Secure Fabric OS policies after Secure Mode is enabled. The
member list of each policy determines the devices or switches to which the policy
applies.
If a policy does not exist, then no Secure Fabric OS controls are in effect for that
aspect of the fabric. If a policy exists but has no members, that functionality is
disabled for all switches in the fabric. Once you add the first member to a policy,
that functionality becomes disabled for all switches except the listed members.
Note:
the changes are saved.
Each supported policy is identified by a specific name, and only one policy of
each type can exist except for DCC policies. The policy names are case sensitive
and must be entered in all upper case. You can create multiple DCC policies using
the naming convention DCC_POLICY_nnn, with nnn representing a unique
string.
Note:
Fabric OS database after creating the desired Secure Fabric OS policies. The
configupload command can be used to upload a copy of the configuration file,
which contains all the Secure Fabric OS information. For more information about this
command, refer to the
Guide
Policy members can be specified by device port WWN, switch WWN, Domain
IDs, or switch WWN, depending on the policy. The valid methods for specifying
policy members are listed in
58
Save policy changes frequently; changes are lost if the switch is rebooted before
It is strongly recommended that you upload and save a copy of the Secure
HP StorageWorks Fabric OS Version 3.1.x/4.1.x Reference
.
Table 3.
Secure Fabric OS Version 1.0 User Guide