Command List; Portcfgspeed; Syntax; Availability - HP StorageWorks MSA 2/8 - SAN Switch User Manual

ISL Trunking Commands

Command List

Table 3
Trunking.
Table 3: Fabric OS Commands Related to ISL Trunking

portcfgspeed

portcfgtrunkport
switchcfgspeed
switchcfgtrunk
trunkdebug
trunkshow
portcfgspeed

Syntax

This command uses the following syntax:

Availability

This command is available to admin users only.

Description

Use this command to specify the speed of a port to a particular level. After this
command is issued, the port is disabled and then enabled so that the port comes up
with the new speed setting. The configuration is saved in the non-volatile memory
and is persistent across switch reboot or power cycle.
48
provides summary information about the commands that relate to ISL
Command
portcfgspeed <[slotnumber/]portnumber [speedlevel]>
Function
Use to specify the port
speed.
Use to enable or disable
trunking for a port.
Use to set all ports of the
switch to a particular speed.
Use to enable or disable
trunking for all the ports of a
switch.
Use to debug a trunk link
failure.
Use to display trunking
information.
ISL Trunking Version 3.1.x/4.1.x User Guide
Limitations
Enter on the switch with
the port to be configured.
Enter on the switch with
the port to be configured.
Enter on the switch to
specify port speeds.
Enter on the switch to
enable or disable ISL
Trunking.
Enter on the switch to
debug a trunk failure.
Enter on the switch to
show ISL Trunking
information.