HP StorageWorks MSA 2/8 - SAN Switch User Manual page 51

3. Open a sectelnet or SSH connection to the switch that you intend to be the
Note:
You can enter the secmodeenable command through a sectelnet or SSH connection
only.
4. Log into the switch as Admin.
5. Terminate any other sectelnet or SSH sessions in the fabric (when using the
6. Enter the secmodeenable command with no operands to use the
7. Enter the following passwords at the prompts, using unique passwords that are
Note:
Secure Fabric OS Version 1.0 User Guide
Primary FCS switch.
The login prompt displays.
Most Secure Fabric OS commands must be executed on the Primary FCS switch.
secmodeenable command, no other sessions should be active).
command's interactive mode, or enter the following:
secmodeenable "fcsmember;...;fcsmember"
Where fcsmember is the Domain ID, WWN, or switch name of the
Primary and Backup FCS switches, with the Primary FCS switch listed first.
The command confirms the current login, requests the new passwords
required for Secure Mode, creates and activates the FCS policy, distributes the
information to all switches in the fabric, activates the local zoning
configurations, then fastboots all the switches in the fabric.
different from the default values and contain between 8 and 40 alphanumeric
characters:
Root password for the FCS switch
Factory password for the FCS switch
Admin password for the FCS switch
User password for the fabric
Admin password for the Non-FCS switches
The Root and Factory accounts are disabled on the Non-FCS switches.
All passwords are saved. The new FCS list and passwords are distributed to all
switches in the fabric.
Creating Secure Fabric OS Policies
51