Front Panel Policy States - HP StorageWorks MSA 2/8 - SAN Switch User Manual

Table 10: Front Panel Policy States
No policy
Policy with no entries
Policy with entries
To create a Front Panel policy:
1. From a sectelnet or SSH session, log into the Primary FCS switch as Admin.
2. Enter the following:
3. To save or activate the new policy, enter the secpolicysave or the
primaryfcs:admin> secPolicyCreate "FRONTPANEL_POLICY", "3; 4"
FRONTPANEL_POLICY has been created.
primaryfcs:admin>
Secure Fabric OS Version 1.0 User Guide
Policy State
All the switches in the fabric have front panel access
enabled.
All the switches in the fabric have front panel access
disabled.
Only specified switches in the fabric have front panel access
enabled.
secpolicycreate "policy_name", "member;...;member"
Where:
policy_name is FRONTPANEL_POLICY.
member is a switch WWN, domain ID, or switch name. If a domain ID
or switch name is used to specify a switch, the associated switch must be
present in the fabric for the command to succeed.
secpolicyactivate command.
If neither of these commands are entered, the changes are lost when you log
out. For more information about these commands, see
Secure Fabric OS Policies" on page 77 and
Fabric OS Policies" on page 77.
Example, creating a Front Panel policy to allow only domains 3 and 4 to use
the front panel:
Creating Secure Fabric OS Policies
Characteristics
Saving Changes to
Activating Changes to Secure
69