Adding Secure Fabric Os To Switches Shipped With Fabric Os V3.1.X Or V4.1.X; Customizing The Account Passwords - HP StorageWorks MSA 2/8 - SAN Switch User Manual

Adding Secure Fabric OS to the Fabric
Adding Secure Fabric OS to Switches Shipped with Fabric OS
v3.1.x or v4.1.x
This section applies to the following switches:
All switches that are shipped with Fabric OS v3.1.x or v4.1.x installed already
have the required PKI objects and a digital certificate.
To set up Secure Fabric OS on a switch shipped with Fabric OS v3.1.x or v4.1.x:
1. Change the account passwords from default values as described in
2. If switches running Fabric OS v3.1.x will be in the same fabric as switches
3. Ensure that the switch has an activated Secure Fabric OS and Zoning Software

Customizing the Account Passwords

You are prompted to customize the account passwords at the first login. Changing
the passwords immediately is recommended. Until you change the passwords
from the default values, you are prompted to change them each time you log in,
and the passwd command remains disabled.
Note:
accounts, setting both the Boot PROM and Recovery passwords is strongly
recommended. For instructions on setting these passwords, refer to the
StorageWorks Fabric Operating System Procedures Version 3.1.x/4.1.x User Guide
24
StorageWorks SAN Switch 2/8 EL or StorageWorks SAN Switch 2/16
shipped with Fabric OS v3.1.x
StorageWorks SAN Switch 2/32 shipped with Fabric OS v4.1.x
"Customizing the Account
running Fabric OS v4.1.x, set the Core processor ID (PID) on the v3.1.x
switches accordingly. Refer to the HP StorageWorks Fabric Operating System
Procedures Version 3.1.x/4.1.x User Guide for instructions.
License as described in
Zoning Licenses" on page 25.
In addition to customizing the passwords for the User, Admin, Factory, and Root
Passwords" on page 24.
"Verifying or Activating the Secure Fabric OS and
Secure Fabric OS Version 1.0 User Guide
HP
.