HP StorageWorks MSA 2/8 - SAN Switch User Manual page 61

Table 4: Read and Write Behaviors of SNMP Policies (Continued)
RSNMP Policy
Empty Non-existent
Empty Empty
Empty Host B in policy
Host A in policy Non-existent
Host A in policy Empty
Host A in policy Host B in policy
To create an SNMP or WSNMP policy:
1. From a sectelnet or SSH session, log into the Primary FCS switch as Admin.
2. Enter the following:
3. To save or activate the new policy, enter the secpolicysave or the
Secure Fabric OS Version 1.0 User Guide
WSNMP
Policy
This combination is not supported. If the WSNMP policy is not
defined the next time the Secure Fabric OS policies are saved
or activated, the RSNMP policy fails.
No host can read
Only B can read
This combination is not supported. If the WSNMP policy is not
defined the next time the Secure Fabric OS policies are saved
or activated, the RSNMP policy fails.
Only A can read
A and B can read
secpolicycreate policy_name, "member;...;member"
Where:
policy_name is WSNMP_POLICY or RSNMP_POLICY.
member is one or more IP addresses in dot-decimal notation. You can
enter "0" in an octet to indicate that any number can be matched in that
octet.
secpolicyactivate command.
If neither of these commands are entered, the changes are lost when you log
out. For more information about these commands, see
Secure Fabric OS Policies" on page 77 and
Fabric OS Policies" on page 77.
Read Result
"Activating Changes to Secure
Creating Secure Fabric OS Policies
Write Result
No host can write
Only B can write
No host can write
Only B can write
"Saving Changes to
61