Replacing A Primary Node; Aligning The Processor Pins With The Socket Holes; Closing The Processor Locking Lever And Retaining Clips - HP StorageWorks 300 - Virtual Library System EVA Gateway User Manual

Figure 84 Aligning the processor pins with the socket holes
3.
Install the processor and close the processor locking lever (2) and processor retaining clips (1).
Figure 85 Closing the processor locking lever and retaining clips
4. Lower the processor retaining card.
5.
Install the access panel. See
6. Slide the node into the rack.
7. Power on the node. See

Replacing a primary node

CAUTION:
Each VLS300 node weighs 16.78 kg (37 lb) full. At least two people are required to lift and move
each node.
To replace a primary node:
1.
Remove the existing node from the rack:
a. Power off the system. See
b. From the back of the node, make a note of all cable connections then disconnect the cables.
1
1
3
2
Installing the VLS node access
Powering on the VLS300
Powering off the system.
panel.
system.
139
HP StorageWorks