HP StorageWorks 300 - Virtual Library System EVA Gateway User Manual page 120

Item Description
1
Power On/Standby button and
system power LED
2
UID button/LED
3
Internal health LED
4 External health LED (power
supply)
5
NIC 1 link/activity LED
6
NIC 2 link/activity LED
NOTE:
SATA hard drive LED functionality is not currently supported.
120
Component identification
Status
• Green = System is on.
• Amber = System is shut down, but
power is still applied.
• Off = Power cord is not attached,
power supply failure has occurred, no
power supplies are installed, facility
power is not available, or the DC-to-DC
converter is not installed.
• Blue = Identification is activated.
• Flashing blue = System is being
managed remotely.
Off = Identification is deactivated.
•
• Green = System health is normal.
• Amber = System is degraded. To
identify the component in a degraded
state, refer to system board LEDs.
• Red = System is critical. To identify the
component in a critical state, refer to
system board LEDs.
• Off = System health is normal (when
in standby mode).
• Green = Power supply health is normal.
• Amber = Power redundancy failure
occurred.
• Off = Power redundancy failure has
occurred. When the node is in standby
mode, power supply health is normal.
• Green = Network link exists.
• Flashing green = Network link and
activity exist.
• Off = No link to network exists.
If power is off, view the LEDs on the RJ-45
connector for status by referring to the rear
panel LEDs.
• Green = Network link exists.
• Flashing green = Network link and
activity exist.
• Off = No link to network exists.
If power is off, the front panel LED is
not active. View the LEDs on the RJ-45
connector for status by referring to the rear
panel LEDs.