Cli Monitoring Commands 1 - HP StorageWorks 300 - Virtual Library System EVA Gateway User Manual

• View or delete notification alerts
• Add, view, or delete mail servers to route notification alerts
• Add, view, or delete mail addresses for notification alerts
• Add, view, or delete SNMP management consoles to receive notification alerts
Table 9 CLI monitoring commands
Command
getHealth
getChassis
getNodeNames
getNodeFault
getNotificationsCount
getNotificationsDate
deleteNotifications
addEmailServer
getEmailServer
deleteEmailServer
1 16
CLI command set
Usage
1
Returns the VLS health status as a number (0-good,
1-degraded, 2-critical, 3-failed, 4-missing).
Returns information about the VLS displayed on the
Identity Tab window.
Returns the list of nodes in the VLS.
Returns fault information for the specified node. Where
the options are:
-a <s> - Node name (Head_0, ...) (required)
-h - Displays command usage information (optional)
Returns the number of notification messages specified
counting back from the most recent. Where the options
are:
-n <n> - Maximum number of notifications to return
(required)
-h - Displays command usage information (optional)
Returns all the notification alert messages that occurred
starting with the specified date. Where the options
are:
-d - mm/dd/yy on or after this date (required)
-h - Displays command usage information (optional)
Deletes the specified notification alerts from the VLS.
Where the options are:
-id <s> - ID number of notification to delete
(required)
-h - Displays command usage information (optional)
Specifies an mail server with an SMTP gateway to
route notification alerts from the VLS. Where the
options are:
-a <s> - E-mail server address (required)
-c <s> - node IP address (required)
-h - Displays command usage information (optional)
Returns the mail server configuration settings for
notification alerts.
Deletes the specified mail server from the mail
notification alerts settings. Where the options are:
-a <s> - E-mail server address (required)
-c <s> - VLS node IP address (required)
-f - Force - Do the delete without a prompt (optional)
-h - Displays command usage information (optional)