Table of Contents
Advertisement
Figure 5 Switch 2824 rail installation, front
c.
At the front of the rack, slide the clip onto the rack so that the hexagonal hole is facing out
and align the holes in the clip with the proper hole in the rack. Then align the rail hole with
these holes.
Figure 6 Switch 2824 rail installation, back
d. Push the screw through the rail, clip, and rack, then into the nut. Tighten the screw to secure
the rail to the rack (see
e.
Repeat these tasks for the rail on the other side of the rack.
Attach rails to the 2824 switch
To attach the rails to the 2824 switch:
1.
Align the inner rail with the switch so that the perpendicular screw hole faces away from the switch
but is parallel to the switch bezel (face-plate). The two holes at the front of the rail must align with the
two holes at the front of the switch (see
1
Figure
6).
11194
2
11195
Figure
7).
29
HP StorageWorks
Advertisement
Table of Contents
Need help?
Do you have a question about the StorageWorks 300 - Virtual Library System EVA Gateway and is the answer not in the manual?
Questions and answers