Table of Contents
Advertisement
Figure 4 Switch 2524 mounting brackets
b. Adjust alignment so that the holes in the side of the mounting bracket line up with the holes in
the switch.
c.
Use a #1 Phillips (cross-head) screwdriver and the four M4 screws (included) to attach the
mounting brackets to the switch.
2.
Place the switch on top of node 0 in the rack.
3.
Align the holes of the mounting brackets on both sides of the switch's bezel with the holes in the rack.
4.
On each side of the switch, insert a Phillips screw through the holes in the mounting bracket and into
the holes in the rack.
5.
Tighten the Phillips screws to secure the switch to the rack.
6.
Connect the power cable to the front of the switch, run the cable through the holes in the rack to the
back of the rack but do not connect the cable to a PDU at this time.
Install the 1 Gb Ethernet switch 2824 into a rack
To install a node into the rack involves three main tasks:
• Install rails for switch 2824 in the rack
• Attach rails to the 2824 switch
• Install switch 2824 in rack
Install rails for switch 2824 in the rack
1.
Locate the correct rail kit—part number 356578–B21.
2.
Install the two slide rails to the sides of the rack.
a. Locate four of the MS screws and insert each one into a square, semi-pierced washer (included).
b. At one side of the rack, align the front rail holes with the holes in the back of the rack Secure by
inserting two of the provided MS screws and semi-pierced washers through the two outermost
holes in the rail and into the rack (see
28
Hardware installation
Figure
5).
11192
Advertisement
Table of Contents
