Setting The Network Settings Using Command View Vls - HP StorageWorks 300 - Virtual Library System EVA Gateway User Manual

To set the network settings using the CLI command set:
1.
Open a serial session and log in to the administrator account. See
2. To see the current configuration settings, at the prompt enter:
showConfig
3.
Set each desired configuration value by entering:
setConfigValue <-tag> [value]
where <-tag> can be any of the following:
Tag
-host
-domain
-full-
host
-dnsaddr
-dnsaddr1 First DNS server address (cannot use with dnsaddr)
-dnsaddr2 Second DNS server address (cannot use with dnsaddr)
-dhcp
-ipaddr
-gate
-mask
NOTE:
More than one network value can be set at a time or you can set them individually.
To reset a value, enter " " (quoted space) as the value.
4.
Verify the network setting(s) has been changed by entering:
showConfig
5.
When all the network parameters are set to your desired values, save the settings by entering:
commitConfig

Setting the network settings using Command View VLS

To set the network settings using Command View VLS, set either the:
• DHCP usage and host name, or
• Fully qualified host name (or host name and DNS domain name separately), DNS server address,
IP address, gateway, and netmask
To set the network settings using Command View VLS:
1.
Open a Command View VLS session and log in as the administrator. See
View VLS session from Command View
2.
On the System tab, select Chassis in the navigation tree.
3.
Select Set Network Configuration under Maintenance Tasks.
64
Configuration
Description
Host name (such as vlsexamp) (unqualified)
DNS domain name (such as xyz.com)
Fully qualified name (such as vlsexamp.xyz.com)
DNS server address (replaces all addresses with one
line)
Has no value, indicates you want to configure the
public Ethernet connection using DHCP (reset is
-dhcp=false)
IP address of public Ethernet connection
Gateway to network (xx.xx.xx.x)
Netmask. Default is 255.255.255.0
TL.
Opening a serial session.
Opening a Command