Table of Contents
Advertisement
Command
createCartridge
getCartridges
getCartsByLib
Usage
1
Creates the specified number of cartridges with the specified
barcode and associated with the specified library.
Note: If you specify more cartridges than slots defined for
the library, this command only creates enough cartridges for
the slots available. That is, if your library has 100 slots and
you specify 125 total cartridges, this command creates 100
cartridges. Likewise, if 50 cartridges were already created
for this library, this command would create only 50 more
cartridges, even though 125 are specified by the command.
Where the options are:
-a <s> - Cartridge name (DLT, ...) (required)
-b <s> - Barcode prefix (required)
-c <n> - Capacity in gigabytes (required)
-i <n> - Barcode start index (required)
-l <s> - Library name (Library_0, ...) (required)
-n <n> - Number of cartridges (required)
-ov <n> - Oversubscribe (0 or 1) (required)
-u <n> - Barcode suffix length (required)
-y <n> - Cartridge type (2, ...) (required)
-h - Displays command usage information (optional)
Returns a list of the cartridges that have been created. All
cartridges have both a VLS filename (cartridge name) and a
barcode label. This command returns the following cartridge
metadata:
•
Storage pool the cartridge resides (SD_1_0)
•
Cartridge VLS filename
•
Cartridge capacity (in GB)
•
Consumed capacity (in GB)
•
Cartridge type
•
Timestamp value for when it was last loaded
•
Whether or not it is write-enabled (0) or write-protected (1)
•
Library to which it belongs
•
Barcode label
Returns a list of the cartridges associated with the specified
library. Where the options are:
-a <s> - Name of library (Library_0, ...) (required)
-h - Displays command usage information (optional)
1 13
HP StorageWorks
Advertisement
Table of Contents
