Installing Capacity Licenses - HP StorageWorks 300 - Virtual Library System EVA Gateway User Manual

A second page of the Confirm Destroy <storagepool name> screen is displayed, containing the
following text: WARNING: Existing data in StoragePool # will be destroyed and cannot be recovered.
This step cannot be reversed.
5.
Select Finish to display the screen confirming that the storage pool has been destroyed.
6.
Select Finish again to return to the system screen.
You can now either use the LUNs previously assigned to the destroyed pool in other pools, or
they can be deleted.
To delete all storage pools:
1.
Open a Command View VLS session and log in as the administrator. See
View VLS session from Command View
2. In the Storage tab navigation tree, select Storage Pools.
3.
If you wish to destroy all storage pools, from the task bar, select Destroy All Storage Pools. The
Confirm Destroy All Storage Pools screen is displayed.
4. Select Next to destroy the pools.
Either recreate storage pools using the LUNs previously assigned to the destroyed pool(s), or delete
them.

Installing capacity licenses

A VLS capacity license must be installed on the VLS when storage exceeds the base license. If you are
in a license violation state, all VLS read/write operations are disabled until either sufficient licenses
are installed to support the storage, or until excess storage is removed. Unconfigured VLS300 array
LUNs are counted by the system; therefore, they can contribute to license violation. When you have
cleared a license violation by installing an upgrade capacity license, the VLS read/write operations are
automatically enabled without requiring a reboot.
NOTE:
HP OpenView Command View for TL User Guide
See the
steps.
The VLS network settings must be set before a capacity license can be installed. See
settings.
To install a capacity license on the VLS:
1.
Install Command View TL.
2.
Start Command View TL.
3.
Complete the Command View TL initial configuration steps.
4.
Add the VLS to Command View TL.
5.
Open a Command View VLS session from Command View TL for the VLS. See
View VLS session from Command View
6. Click the Identity tab.
The Identity tab window opens
TL.
for instructions on performing the following
TL.
(Figure 21).
Opening a Command
Setting the network
Opening a Command
HP StorageWorks
45