NOTE:
The ejector button for the CD-ROM drive is recessed to prevent accidental ejection; it may
be helpful to use a small, blunt object, such as a pen, to push the ejector button.
2.
Press the ejector button in firmly until the CD-ROM drive ejects (1).
3.
Pull the CD-ROM drive out of the node.
Figure 74 Ejecting the CD-ROM drive
To replace the component:
1.
Carefully align the connector on the rear of the drive with the connector on the CD-ROM/diskette
drive interface board.
2.
Slide the drive into the bay until it clicks.
Power supply
CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless all bays are populated
with either a component or a blank.
1.
Disconnect the power cord from the power supply.
2.
Press the power supply release lever (1), and then pull the power supply from the node.
Figure 75 Removing a node power supply
To replace the component:
1
2
1
2
133
HP StorageWorks