Figure 79 Removing the processor zone fan module
To replace the component, reverse the removal procedure.
DIMM
1.
Power off the node. See
2.
Extend or remove the node from the rack. See
3.
Remove the access panel. See
4.
Open the DIMM slot latches (1).
5.
Remove the DIMM.
1
Figure 80 Removing the node DIMM
CAUTION:
Use only Compaq branded or HP DIMMs. DIMMs from other sources may adversely affect data integrity.
To replace the component, reverse the removal procedure.
NOTE:
DIMMs do not seat fully if turned the wrong way.
When replacing a DIMM, align the DIMM with the slot and insert the DIMM firmly, pressing down until
the DIMM snaps into place. When fully seated, the DIMM slot latches lock into place.
136
Component replacement
3
Powering off the
Removing the VLS node access
2
1
2
system.
Extending the node from the
panel.
1
rack.