Send After Scan Enable - Xerox WorkCentre Pro 575 Advanced Features Manual

Transmitting Documents
5-24

Send After Scan Enable

Once the Send After Scan Mode Default Setting is set to "OFF", this
feature allows you enable the Send After Scan mode for a single
transmission. Once that transmission is complete, the default status
is regained.
To set the Send After Scan feature:
1. Load the document face down in the Document Support.
2. Select the desired Resolution and Contrast .
3. Press:
Menu
4. Select the Send After Scan option.
To enable the Send After Scan Mode for this transmission, press
, then go to step 5.
To disable the Send After Scan Mode for this transmission, press
, then go to step 6.
Send after scan
2.Off
1.On
When memory full
1.Cancel sending
2.Send scanned pages
WorkCentre Pro 555/575