Table of Contents
Advertisement
5
Transmitting Documents
WorkCentre Pro 555/575
Transmission Modes
The WorkCentre offers various transmission modes to simplify the
faxing process. Each transmission mode may be performed using
any one of the dialing methods described in the previous section.
•
Memory Send — The job is first scanned into memory, then sent
to the remote party. Using this method, multiple jobs can be
stored and the machine transmits each job as the line becomes
available.
•
Direct Send — The job is transmitted, page by page, without
being stored in memory. Using this method you can observe the
transmission procedure, one page at a time.
•
Delayed Start — The transmission is programmed to be sent at a
later designated time. This feature permits cost savings by
scheduling transmissions during periods when telephone rates
are lower.
•
Priority Transmission — A priority send transmission is
performed prior to any other job reserved in memory.
•
Resend — Normally, document data (stored in memory for
transmission) is cleared if the transmission fails to reach a remote
facsimile. This function enables the machine to save the stored
document and allows you to re-schedule the transmission.
•
Group Transmission — Sends the same document to more
than one location via multiple, sequential transmissions.
Sometimes referred to as broadcast.
•
Relay Transmission — Sends a document to a relay station.
The relay station then sends the document to another relay
station or to the final receiving stations. The origination and relay
stations must be ITU-T relay communication compatible units.
•
Mailbox Communications — The Mailbox feature allows you to
store documents in memory on your machine, or that of a remote
machine, with a Mailbox number. Other remote parties can then
Transmitting Documents
5-1
Advertisement
Table of Contents
Troubleshooting
