Transmitting Documents
5-22
ECM Disable
Once the Error Correction Mode Default Setting is set to "ON", this
feature allows you to disable the ECM mode for a single transmission.
Once that transmission is complete, the default status is regained.
Note: ECM must be set to On when the 33.6K BPS Modem is
installed. Disabling ECM also turns the 33.6K BPS Modem
off. If the ECM Default setting is set to "OFF", the ECM
Disable feature is not available. (See Chapter 2, "Error
Correct — ECM Default Setting".)
To set the ECM feature:
1. Load the document face down in the Document Support.
2. Select the desired Resolution and Contrast .
3. Press:
Menu
4. Select the ECM option:
To send the document using ECM, press
To disable the ECM Mode for this transmission, press
5. Press Menu to select additional fax options, or using one of the
dialing methods, enter the fax number, then press Enter if
necessary.
The document is sent and the machine returns to the Standby Mode.
Error correct-ECM
1.On
2.Off
.
Error correct-ECM
Enter fax number
WorkCentre Pro 555/575
.