Ykercode Command - HP StorageWorks P9000 Reference Manual

BCM log output method: LOGR
CLI log output settings: YES
YKCMDIF = N/A
YKLCNSE = N/A
YKLCNS2 = N/A
LOGPUT = N/A
SYSLOG = N/A
YKZ371I YKENV command return code=0.

YKERCODE Command

Format
YKERCODE
error-code
1
Function
This is a TSO/E command.
This command displays the details of a specified error code on the TSO/E terminal.
The command displays the following information:
Error details:details-of-error
Displays the error details.
Type of error:cause-of-error
Displays the cause of the error. Possible choices are: BC, CA, CAA, CAJ, CMD (command
device), PATH (logical path), or Others (other).
Parameters
error-code ~ <4 hexadecimal characters>
Specify the storage system sense byte information (error code) that is included in the message
displayed by Business Continuity Manager. For details on error codes, see the section that describes
storage system sense byte information in the HP StorageWorks P9000 for Business Continuity
Manager Software Messages.
Example
The following shows an example of executing the YKERCODE command.
READY
YKERCODE 6A13
Error details:
The command could not be executed because a remote command was executed
while the command device was not defined.
Type of error:
Others.
Return codes
Table 1 1 1 (page 208)
terminates.
Table 1 1 1 YKERCODE Command Return Code List
Return Code
0
8
208 CLI Commands
(&YKCMDIF = N/A
(&YKLCNSE = N/A
(&YKLCNS2 = N/A
(&YKLOGPT = N/A
(&YKSYSLG = N/A
lists the return codes that are returned when the YKERCODE command
Meaning
The command completed normally.
No description of the specified error code was found.
)
)
)
)
)