Brother Entrepreneur Pro PR1000e Operation Manual page 54

EMBROIDERING TUTORIAL
2 Move the left arm to align the screw on the
right side with the mark for the embroidery
frame to be installed, and then tighten the
thumb screws.
For this example, align with mark 5.
1 Mark for extra-large embroidery frame
200 mm (H) × 360 mm (W) (7-7/8 inches (H) ×
14 inches (W))
2 Mark for extra-large embroidery frame
200 mm (H) × 300 mm (W) (7-7/8 inches (H) ×
11-3/4 inches (W)) (optional)
3 Mark for large embroidery frame
130 mm (H) × 180 mm (W) (5-1/8 inches (H) ×
7-1/8 inches (W))
4 Mark for medium embroidery frame
100 mm (H) × 100 mm (W) (4 inches (H) × 4
inches (W))
5 Mark for small embroidery frame
40 mm (H) × 60 mm (W) (1-1/2 inches (H) × 2-
3/8 inches (W))
Note
● Please firmly tighten the two thumb screws
with included disc-shaped screwdriver. The
machine will recognize the wrong frame
size, if the two screws are not tightened.
The embroidery frame holder is ready for
the embroidery frame to be attached.
52
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
3 Hold the embroidery frame level, and then
simultaneously align both the left and right
mounts with the embroidery frame holder
clips.
• The inner frame should be on top.
Note
● Attach the embroidery frame to place the
needle plate under the embroidering area
otherwise the embroidery frame hits the
needle plate.
1 Needle plate
● If the outer frame is on top, as shown
below, the embroidery frame is incorrectly
attached.
4 Insert the embroidery frame until it snaps
into place.
1 Make sure that the pins on the left and right arms
of the embroidery frame holder fit into the
positioning slot and hole on the embroidery
frame.