Brother Entrepreneur Pro PR1000e Operation Manual page 169

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
When connecting the USB card reader/writer
to the machine's USB port, be sure to secure
the cable with the two hooks on the back
panel. If the cable is not secured, the
embroidery frame may catch on the cable
while the frame is moving, causing the
pattern to become misaligned.
2 Insert the card completely into the card
reader/USB card writer module*.
• Insert the embroidery card so that the end
with a printed arrow is facing up.
● Two embroidery USB card readers/USB
card writer module* cannot be used with
this machine at the same time. If two
embroidery USB card readers/USB card
writer module* are inserted, only the
embroidery USB card reader/USB card
writer module* inserted first is detected.
● If an embroidery card other than our
original embroidery cards are used, the
embroidery machine may not operate
correctly. Be sure to use only
recommended embroidery cards.
● Some licensed or copyright cards may not
be compatible with this embroidery
machine.
Note
Memo
● You can also plug the embroidery card
reader/USB card writer module* into the
center port of the machine.
3 Touch the key of the USB port that the
embroidery card reader/USB card writer
module* is plugged into.
The list of patterns on the embroidery card
appears.
4 Select the pattern as described on page 154
to 165.
■ With patterns larger than 200 mm (H) × 360 mm
(W) (7-7/8 inches (H) × 14 inches (W))
When a pattern larger than 200 mm (H) × 360 mm
(W) (7-7/8 inches (H) × 14 inches (W)) is selected,
the following message appears.
Touch to rotate the pattern 90 degrees
before opening it.
Selecting an Embroidery Pattern 167
5