— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
3
Check the size of the pattern, and then hoop
fabric that is large enough in the optional
jumbo frame.
* For details on attaching the optional jumbo
● When hooping the fabric, position it
within the embroidery frame so there is at
least 10 mm of space to the inside of the
frame.
1 more than 10 mm (3/8 inch)
2 Location where the pattern is to be embroidered
4
Attach the jumbo frame to the machine.
5
Touch
frame, refer to "Hooping the Fabric" on
page 94.
Note
.
Note
● When you change the embroidering
position using the jumbo frame, be sure to
be aware of the size of the combined
pattern. You cannot change the position
exceeding the embroidery area.
1 Embroidery area
6
Touch
stop button to start embroidering the first
section of the pattern.
7
After embroidering of the first section of the
pattern is finished, the following message
appears. Touch
Embroidery Patterns for the Optional Jumbo Frame 255
, and then press the start/
.
7