Trimming The Threads Between Characters; Changing The Thread Density (Only For Selected Character And Frame Patterns) - Brother Entrepreneur Pro PR1000e Operation Manual

Users manual - english
Hide thumbs Also See for Entrepreneur Pro PR1000e:
Table of Contents

Advertisement

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
5
Touch
Trimming the threads
between characters
If the machine is set to trim the threads between the
characters, the jumpstitches between the characters
are reduced and any other necessary procedures
after embroidering are reduced. However, the
embroidering time will increase if the threads are
trimmed between each of the characters.
1
Touch
• Each touch of the key turns the setting
either on or off.
Threads are not
trimmed.
.
so that it changes to
Threads are
trimmed.
Editing the Embroidery Pattern (Pattern Editing Screen) 189
Changing the thread density
(only for selected character and frame
patterns)
The thread density for some character and frame
patterns can be changed.
A setting between 80% and 120% in 5%
increments can be specified.
1
Touch
The screen shown below appears.
.
1
2
3
1 Selects a less thread density
2 Selects a more thread density
3 Touch this key to close this screen.
■ Selects a less/more thread density
Less
.
Standard
More
5

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Entrepreneur pro pr-1000

Table of Contents