Optional Accessories; Embroidery Patterns For The Optional Jumbo Frame - Brother Entrepreneur Pro PR1000e Operation Manual

APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

OPTIONAL ACCESSORIES

Embroidery Patterns for the Optional Jumbo Frame

Patterns can be created in embroidery editing software version PE-DESIGN NEXT or later to be used with the
Jumbo frame (optional).
When a jumbo frame pattern is created in embroidery editing software, the pattern is automatically divided
into two sections that can be combined into a single embroidery design when it is sewn with the jumbo
frame. When the jumbo frame is used, embroidery with a maximum size of 350 mm × 350 mm (14 inches ×
14 inches) can be sewn without having to shift the fabric within the frame.
For details on creating jumbo frame patterns, refer to the Instruction Manual provided with the embroidery
editing software version PE-DESIGN NEXT or later.
After the jumbo frame pattern has been created, follow the procedure described below to transfer the pattern
to the machine using USB media and begin embroidering.
1 Connect the USB media containing the
jumbo frame pattern to this machine, and
then select the jumbo frame pattern from the
pattern selection screen.
* For details on importing the pattern, refer to
"USB media" on page 173.
254
2 Touch to select the first section of the
pattern to be embroidered, and then touch
.
Note
● Before you start sewing the jumbo frame
pattern, prepare the optional jumbo frame.
● Contact your authorized dealer for
purchasing the optional jumbo frame.
● After hooping fabric or a garment, make
sure that the inner frame is lower than the
outer frame so that the frame sits flat
against the extension table.