Brother Entrepreneur Pro PR1000e Operation Manual page 174

SELECTING/EDITING/SAVING PATTERNS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Note
● Do not insert the Allen screwdriver too far
into the hole in the protective cap;
otherwise, the machine or the Allen
screwdriver may be damaged.
2 Open the USB cord clamp.
• With your fingernail, press on the tab to
open the clamp.
1 Tab
3 Hold the clip end of the USB cord clamp,
and then firmly insert the other end into the
screw hole where the protective cap was
removed.
172
4 As described in steps
the protective cap from the rear screw hole
on the side of the machine, and then insert
an opened USB cord clamp.
5 Check that the USB cord clamps have been
firmly inserted into the front and rear screw
holes on the side of the machine.
• If the USB cord clamps are not firmly
inserted into the screw holes, they are not
correctly installed. Firmly insert the cord
clamps into the screw holes.
1
6 Pass the USB cable through the front USB
cord clamp, and then close the clamp to
secure the cable.
Note
● When passing the USB cable through the
clamp, do not insert it with excessive
force; otherwise, the clamp may break.
1 3
through , remove