Brother Entrepreneur Pro PR1000e Operation Manual page 254

APPENDIX — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
3 Pull the table toward you until the pins on
the mounting brackets (attached on each
side to the bottom of the table) fit into the
notches in the guide plates.
1 Pin
2 Notch
4 Slide in the table while supporting it so that
it remains level. Push the table in until it
lightly touches the machine.
• If the table does not move smoothly,
slightly lift it up, and then slide it in.
252
5 While looking below the table, lightly lift it
up, and then lower it so that the screw fits
into the notch at the front of the guide plate.
1 Notch at front
6 Tighten the two thumb screws so that the
table is secured.
1 Thumb screw