Brother Entrepreneur Pro PR1000e Operation Manual page 263

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
1 Loosen and then remove the two thumb
screws and the embroidery frame holder.
1 Thumb screws
• The removed thumb screws remain
attached to the embroidery frame holder.
1 Put the two thumb screws back in the
embroidery frame holder.
2 Remove the two upper thumb screws of the
cap frame driver and set aside. Loosen the
two lower thumb screws (4 turns).
1 Upper thumb screws
2 Lower thumb screws
3 Pass the machine bed through the ring of the
cap frame driver.
1 Machine bed
Note
● Be careful that the cap frame driver does
not hit any nearby parts, such as the
presser foot.
Attach the cap frame driver to the carriage as
described below in steps
Using the Optional Cap Frame 261
4 7
through .
7