Computer (Usb) - Brother Entrepreneur Pro PR1000e Operation Manual

SELECTING/EDITING/SAVING PATTERNS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Note
● The processing speed may vary by port
selection and quantity of data. The
primary (top) USB port processes the data
faster than the center port. It is
recommended to use the primary (top)
USB port.
● Two USB media cannot be used with this
machine at the same time. If two USB
media are inserted, only the USB media
inserted first is detected.
● Do not insert anything other than USB
media into the USB media port.
Otherwise, the USB media drive may be
damaged.
3 Touch .
• Touch to return to the original
screen without saving.
The "Saving" screen is displayed. When
the pattern is saved, the display returns to
the original screen automatically.
Note
● Do not unplug the USB media while
"Saving" is displayed, otherwise the USB
media may be damaged or data may be
lost.
● Do not unplug a USB device/media from
this machine immediately after it has been
plugged in. Be sure to wait at least 5
seconds before unplugging the USB
device/media.
214

Computer (USB)

Using the included USB cable, the embroidery
machine can be connected to your computer, and
the embroidery patterns can be saved in the
"Removable Disk" folder in your computer. A total
of about 3 MB of embroidery patterns can be saved
in the "Removable disk", but the saved embroidery
patterns are deleted when the machine is turned
off.
Also, this machine is compatible with the Link
function, this function enables you to send
embroidery patterns edited on a computer to the
embroidery machine. (Refer to "Sending
Embroidery Patterns From a Computer to the
Machine (Link Function)" on page 176.)
Note
● Do not turn off the machine while the
"Saving" message is displayed, otherwise
the pattern data being saved may be lost.
1 Plug the USB cable connector into the
corresponding USB ports for the computer
and for the machine.