Removing And Replacing The Power Supply Interface Module; Removing The Power Supply Interface Module; Power Cables And Holding Clips - HP rp3440 Service Manual

14. Perform the resetting with the changes in effect.
CAUTION:

Removing and Replacing the Power Supply Interface Module

The Power Supply Interface (PSI) module supports up to two redundant power supplies.

Removing the Power Supply Interface Module

To remove the power supply interface module, follow these steps:
1. Power off the server and disconnect all the power and external cables.
2. Remove the top cover. (See
3. Remove the system board. (See
4. Lift the power cables out of their metal holding clips.
Figure 6-74 Power Cables and Holding Clips
186 Removing and Replacing Components
If this procedure is not followed, the server components will not be functional.
"Removing and Replacing Server Covers and Bezel" (page
"Removing the System Board" (page
126).)
177).)