Hard Drive Lock - HP rp3440 Service Manual

4. Close the drive ejector handle by pushing it down until it clicks.
5. If desired, lock the hard drive in place.
a. Press the hard drive locking lever down into the locked position.
b. Replace the cover and bezel. (See
(page 52).)
Figure 3-21 Hard Drive Lock
6. Verify the drive installation by using the system utilities.
• Use the iLO MP commands to verify operation.
• Use the BCH commands to verify operation.
• Use diagnostics provided by the offline diagnostic environment to exercise the module
added.
7. If rack-mounted, slide the server back into the rack until it stops.
8. Check the installation of the hard disk drive by powering on the server and checking the
virtual front panel and System Event Log (SEL) for correct status for the hard disk drive.
"Removing and Replacing Server Covers and Bezels"
Installing Additional Components 63