3.
Screw in the system board mounting screw.
4.
Connect all the cables to their appropriate connectors on the system board.
5.
Screw in the six rear backplane system board mounting screws.
Figure 6-70 Installing the Rear Panel Mounting Screws
6.
Replace the mechanical covers over the VGA and DB9 ports.
Figure 6-71 Replacing Mechanical Covers
7.
Replace the power connectors in their slots on the back of the server and screw in the power
connector mounting screws.
Figure 6-72 Reinstalling the Power Connectors
8.
Replace the following server components:
•
iLO MP card. (See
•
Dual processor modules. (See
•
Memory DIMMs. (See
182
Removing and Replacing Components
"Replacing the iLO MP Card" (page
"Installing a Dual Processor Module" (page
"Installing System Memory" (page
174))
160))
152))