Securing The Captive Screws; Power Module Shims - HP rp3440 Service Manual

Figure 6-47 Securing the Captive Screws
10. If you are installing a second dual processor module in a server which contained only one
dual processor module, remove the spacers from the power module mounting:
a. Locate the two power module shims on the system board.
b. Remove the holding screws that hold the shims in place.
c. Remove the spacers from the holding screws. Discard the spacers.
d. Retain the screws for use when installing the power module.
Figure 6-48 Power Module Shims
11. Slide the power module on the system board metal mounting bracket so that the connector
on the power module makes contact with its connector on the dual processor module.
162 Removing and Replacing Components
(Figure 6-48.)