Installing Internal Hard Disk Drives; Aligning The Pedestal Front Bezel; Front View Of The Hp 9000 Rp3410/Rp3440 Server - HP rp3440 Service Manual

Figure 3-17 Aligning the Pedestal Front Bezel
3. Rotate the bezel against the chassis so that it snaps into place.

Installing Internal Hard Disk Drives

This section provides information about installing additional internal hard disk drives.
CAUTION:
device can be safely installed into the server. Verify that the operating system supports installing
disk drives while the operating system is running. If the operating system does not support this
feature, shut down the operating system before attempting this procedure. Failure to observe
this caution will result in system failure.
Figure 3-18 Front View of the HP 9000 rp3410/rp3440 Server
Two additional hard disk drives can be added to the server in slots 2 and 3. Always use low
profile disk drives (1 inch height) in HP 9000 rp3410 and rp3440 servers.
To install a hard disk drive, follow these steps:
A hot-pluggable device can require interaction with the operating server before the
Installing Additional Components 61