Removing And Replacing The Power Supply Interface Module; Removing The Power Supply Interface Module; Power Cables And Holding Clips - HP Rx2620-2 - Integrity - 0 MB RAM Service Manual

UUID: A8F2D6EC-DBE5-11D9-9172-AE65D056B60F (Valid)
Secondary UUID is Identical
Product ID: 0x10A
18. Use the EFI date and time commands to set the correct local date and time.
19. Review the system configuration in the Boot Configuration Menu or EFI shell and reconfigure
settings as necessary.
20. Boot the server and resume normal operation.

Removing and Replacing the Power Supply Interface Module

The power supply interface (PSI) module supports up to two redundant power supplies.

Removing the Power Supply Interface Module

1. Power off the server, disconnect all power and external cables, and remove the top metal
cover.
2. Remove the system board. See
3. Remove the power supply (or supplies). See
4. Lift the power cables out of their metal holding clips. See
Figure 4-58 Power Cables and Holding Clips
"Removing and Replacing the System Board" (page
"Removing the Power Supply" (page
Removing and Replacing Internal Components
Figure 4-58.
82).
48).
87