Removing System Memory; Installing System Memory - HP rp3440 Service Manual

NOTE: When replacing deallocated memory ranks on a server with system firmware version
45.11 or greater, you must perform the following procedure before replacing the deallocated
memory. This procedure is necessary to ensure that the memory is properly reallocated upon
server boot.
To ensure the repaired memory rank reallocates properly, follow these steps:
1. Boot to BCH.
2. Enter the in me command to view the deconfigured quad of memory.
3. Enter the ser pdt clear command. The following message displays followed by a 30
second delay:
If DIMM replacement is necessary, power off the system now: Use ^B
MP:CM> PC -OFF -NC, then pull power cord and replace DIMM. Otherwise,
the system automatically reboots in 30 seconds.
4. You must remove power from the system within 30 seconds.
5. For instructions on removing and replacing the memory DIMM, see
Replacing System Memory" (page

Removing System Memory

WARNING!
off and all the power sources have been disconnected from the server.
Voltages are present at various locations within the server whenever an AC power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION:
follow ESD safety precautions can result in damage to the server.
To remove a DIMM, follow these steps:
1. Power off the server and disconnect the power and external cables.
2. Remove the top cover. (See
3. Remove the memory airflow guide. (See
Guide" (page
4. Identify the DIMM to be removed and push the appropriate extraction levers found on
either side of the DIMM connector outward to the open position. The DIMM ejects from the
connector.
5. Remove the DIMM from the socket. If the removed memory is functional, store it in a
static-free container for future use.

Installing System Memory

Memory modules must be loaded in the correct order:
• In the HP 9000 rp3410 server, the first four DIMMs must be installed as ordered pairs of
equal size. The DIMM in socket 0A must match the DIMM in socket 0B. If a second pair is
added (sockets 1A and 1B), the DIMMs must match the DIMMs in sockets 0A and 0B.
Additional DIMMs (DIMM sockets 5 through 12) must be installed as quads (identical groups
of four—two matched pairs). This requirement is summarized as:
• 0A and 0B must be an identical pair
• 1A and 1B must be identical to the pair in sockets 0A and 0B
152 Removing and Replacing Components
Before removing or replacing system memory, ensure that the server is powered
Observe all ESD safety precautions before attempting this procedure. Failure to
"Removing and Replacing Server Covers and Bezel" (page
144).)
149).
"Removing and Replacing the Memory Airflow
"Removing and
126).)