Removing And Replacing Airflow Guides; Removing And Replacing The Memory Airflow Guide; Removing The Memory Airflow Guide; Airflow Guides Locations - HP rp3440 Service Manual

7. Verify the drive replacement and operation by using the system utilities. (For additional
information, see
Guide.)
• Use the iLO MP commands to verify operation.
• Use the BCH commands to verify operation.
• Use diagnostics provided by the ODE to exercise the newly installed module.
8. Reset the server to the BCH Service Menu to rescan the hard drives.

Removing and Replacing Airflow Guides

To upgrade, remove, or replace most server components, you must first remove the airflow
guides from the server chassis.
The server has the following airflow guides:
• The processor airflow guide ensures that the proper volume of air for cooling the processor
module power pods, processor modules, and voltage regulator modules flows over these
components.
You must remove the processor airflow guide:
• If it is damaged to the point that airflow across the dual processor modules is restricted.
• To access components under the airflow guide.
• The memory airflow guide ensures that the proper volume of air flows over the memory
DIMMs to cool them.
You must remove the memory airflow guide:
• If it is damaged to the point that airflow across the memory DIMMs is restricted.
• To access memory DIMMs and sockets.
NOTE:
Air flows through the server from front to back.
Figure 6-27 Airflow Guides Locations

Removing and Replacing the Memory Airflow Guide

Removing the Memory Airflow Guide

To remove the memory airflow guide, follow these steps:
1. Power off the server and disconnect external cables.
144 Removing and Replacing Components
Appendix B (page 199) or the HP Integrity and HP 9000 iLO MP Operations