Accessing The Graphic Console Using Vga; Enabling Vga Graphics Capability; Status Summary Page - HP rp3440 Service Manual

Figure 3-51 Status Summary Page
4. Select the web interface functions by clicking the Function tabs at the top of the page. Each
function lists options in the Navigation Bar on the left side of the page.
5. Click an option link to display data in the Display screen.
6. Click Refresh to update the display.
The iLO MP web interface has a robust help system. To launch iLO MP help, click the Help tab
in the Display screen or click the question mark key (?) at the top right corner of each page to
display help about that page.

Accessing the Graphic Console Using VGA

IMPORTANT:
graphics card to enable VGA grpahics support. See
(page 99).
The graphics capability of the HP 9000 rp3410 or rp3440 server is not supported. The 15 pin VGA
port on the back of your HP server is covered and does not function. DO NOT attempt to attach
a monitor to this port.
Because the graphics chip associated with this port is onboard the MP card and cannot be turned
off, you get an UNCLAIMED UNKNOWN message if you run the ioscan command. This is normal
and can be ignored.
Following is a screen shot of the ioscan screen:
root@myhost> ioscan -fH 0/7/2/0
Class I H/W Path Driver S/W State H/W Type Description
=================================================================
unknown -1 0/7/2/0 UNCLAIMED UNKNOWN PCI Display (10025159)
root@myhost>

Enabling VGA Graphics Capability

To enable graphics capability on your HP 9000 rp3410 or rp3440 server you must install the
supported A6150B graphics PCI card kit in one of the open PCI slots.
Onboard VGA graphics capability is not supported. You must install the A6150
"Enabling VGA Graphics Capability"
Accessing the Host Console 99