Power And System Leds; Lan Leds; Control Panel Leds; System Led States - HP rp3440 Service Manual

Figure 5-1 Control Panel LEDs

Power and System LEDs

The power and system LEDs indicate the state of the system. When the system LED is flashing
yellow or red, a problem exists.
Table 5-3 lists the system LED states.
Table 5-3 System LED States
System LED
Off
Solid green
Flashing green
Flashing yellow (1/sec.)
Flashing red (2/sec.)
For system alerts of levels 3-5, clear the attention condition on the LED. To access the logs, use
the SL command available in the iLO MP command mode.
The fault condition for system alerts of level 7 is cleared by resolving the problem and cycling
power. For additional error information, see the SL error logs.
NOTE: Before replacing any hardware, check the iLO MP status logs in the case of a flashing
yellow or red system LED.

LAN LEDs

The front panel LAN LED indicates the system is communicating over the Gigabit:
Flashing green
Not green
Table 5-4 lists the 10/100/1000 base-T Ethernet LAN connectors LEDs.
118 Troubleshooting
State
AC power is off if the power LED is off
Running OS
Booting or running BCH
Attention: Alerts of levels 3-5 detected in the iLO MP logs
The LED turns off once the event log has been read
Fault: System Alert 7 detected, LED blinks until the problem is resolved and the
system boots successfully
Fatal hardware error detected by BMC, LED blinks until the problem is corrected
The system is communicating over the LAN; the LAN is active.
No LAN cable is attached; LAN network is dead or the system is off or
the LAN link is not established; no current LAN activity.