Powering The Server On And Off; Power States; Ilo Mp Card Lan Leds; Ilo Mp Card Lan Connector Pinouts - HP rp3440 Service Manual

Figure 1-16 iLO MP Card LAN LEDs
Table 1-15 lists the iLO MP card LAN LEDs.
Table 1-15 iLO MP Card LAN LEDs
LED
Self-test
10BT
100BT
Standby power
Table 1-16 lists the iLO MP card LAN connector pinouts.
Table 1-16 iLO MP Card LAN Connector Pinouts
Pin Number
1
2
3
4
5
6
7
8

Powering the Server On and Off

This section provides information on how to power the server on and off.

Power States

The server has three power states:
• Standby power
• Full power
• Off
Plug the power cord into the appropriate receptacle on the rear of the server to achieve the
standby power state; the front panel Power button is not turned on. Full power occurs when the
power cord is plugged into the appropriate receptacle, and either the power is activated through
the iLO MP PC command, or the Power button is activated. In the off state, the power cords are
not plugged in.
Table 1-17 lists the server power states.
38 Overview
Color Description
Yellow iLO MP is running self-test or error is detected
Green 10BT link established, flashing green 10BT link activity, off no link
Green 100BT link established, flashing green 100BT link activity, off no link
Green Standby power on, off standby power off
Signal Description
TXP
TXN
RXP
Not used
Not used
RXN
Not used
Not used