Logging In To The Ilo Mp - HP rp3440 Service Manual

1. Ensure the emulation software device is properly configured. The terminal emulation device
runs software that interfaces with the server. The software emulates console output as it
would appear on an ASCII terminal screen and displays it on a console device screen.
2. To ensure the emulation software is correctly configured, verify the following:
a. Verify that the communication settings are configured as follows:
•
•
•
•
b. Verify that the terminal type is configured appropriately. Supported terminal types are
as follows:
•
•
•
•
IMPORTANT:
There are many different emulation software applications. Consult the help section of your
emulation software application for instructions on how to configure the software options.
3. Use Table 3-5
the server to the console device.
4. Connect the cables.
a. Connect the DB-9 end of the RS-232 serial port female-to-female cable to the console
RS-232 serial port.
b. Connect the other end of the DB-9 female-to-female cable to the console device.
5. Start the emulation software on the console device.
6. Log in to the iLO MP. See
7. At the MP Main Menu, enter CM and press Enter to select command mode.
8. At the command mode prompt, enter LSand press Enter. The screen displays the default
LAN configuration values. Write down the default values or log the information to a file
for future troubleshooting.
9. Use the LC command to disable DHCP.
a. From the LC command menu, enter D and press Enter.
b. Follow the instructions on the screen to change the DHCP status from Enabled to
Disabled.
c. Enter XD -R to reset the iLO MP.
10. Use the LC command to enter information for the IP address, host, subnet mask, gateway
parameters, and so on.
11. Enter XD -R to reset the iLO MP.
12. After the iLO MP resets, log in to the iLO MP again and enter CM at the MP> prompt.
13. Enter LS to confirm that DHCP is disabled and display a list of updated LAN configuration
settings.

Logging In to the iLO MP

To log in to the iLO MP, follow these steps:
1. Access the iLO MP using the LAN, RS-232 serial port, Telnet, SSH, or web method. The iLO
MP login prompt displays.
8/none (parity)
9600 baud
None (receive)
None (transmit)
hpterm
vt100
vt100+
vt-utf8
Do not use hpterm and vt100 terminal types at the same time.
to determine the required connection components and the ports used to connect
"Logging In to the iLO MP" (page 95).
Console Setup 95