Figure 5-2 Location of the STBY and BMC LEDs
Table 5-6
lists the system board LEDs.
Table 5-6 System Board LEDs
LED
STBY
BMC
Cleaning Procedures
This section provides information on how to clean the HP 9000 rp3410 and rp3440 servers.
IMPORTANT:
Table 5-7
provides instructions on how to clean the server.
120
Troubleshooting
Description
This standby LED comes on as soon as the system power cord is plugged in. If this light is off
when you plug it in, reseat the power supply. If this does not work, replace the power supply.
A few seconds after the system is plugged in, this LED starts flashing. This means the BMC is
active.
Power off the server when cleaning it.